Configure a view

Once a Time-Location view has been created, it is possible to modify its display and parameters at any time.

All view settings are accessible through the View Properties window.

---

After selecting the Time-Location view to configure, two methods allow you to open the configuration window.

---

Right-click in the Time-Location planning area, then select the option:

Properties

The view configuration window will then open.

---

It is also possible to access the view properties via the configuration button located at the bottom of the interface, near the reschedule button.

Click this button to open the configuration window.

---

The View Properties window allows you to adjust all the parameters of the Time-Location schedule.

It is organised into two main sections:

• a navigation panel on the left
• a central configuration area

---

The side panel allows navigation between the different elements of the view.

It contains in particular:

• the Time-Location view
• the different Time-Location cells

Each cell corresponds to a display area of the schedule and has its own parameters.

---

The central area contains several configuration tabs allowing the view to be precisely configured.

The main tabs are:

• Scope

defines the general structure of the view

• Display

adjusts the display options of the schedule

• Distance line

configures the information displayed along the project

• Time line

defines the time scales

• Grids

adds visual references within the view

• Layers

controls the display of the different project layers

• Chart Legend

displays additional information

• Printing

configures the view printing settings

The following sections describe in detail the behaviour of each of these tabs.